Latex care and cleaning

Latex cleaning

Step 1: Choose a suitable, clean container. A wash basin is the best choice. If it is a larger item, you can choose a bathtub.

Step 2: Pour warm water and add latex detergent. Only latex-specific detergents can be used. Please be sure to follow the dosage instructions on the detergent.

Step 3: Immerse them completely in water and wash. If foam is produced, it means that too much detergent has been used. In this case, restart the entire washing process and pay close attention to the dosage instructions. The whole process takes a maximum of 2-3 minutes. If there is a lot of dirt, you can repeat this process.

Step 4: Rinse thoroughly with clean water several times.

Step 5: Hang it up to dry

If cleaned properly, the latex will dry immediately. If it does not dry immediately, it means that the latex is still dirty. Then you need to repeat and operate the cleaning process. Remember, if there is still residue or dust that has not been completely removed from the latex, it will not absorb the latex polish.

Latex care

Step 1: Clean the latex. The latex should be freshly washed to absorb the polish. If the clothes are not clean, they will become greasy and sticky after polishing.

Step 2: Pour warm water and then mix in latex oil. Note that only care products specially designed for latex products should be used and follow the dosage instructions on the care products. If too much is used, the latex clothes will become greasy or take a long time to dry.

Step 3: Put the latex clothing in. Soak the surface completely with the polish, and turn the large clothing over if necessary.

Step 4: Pull the latex clothi

Step 5: Hang the latex garment on a hanger to dry. If the correct amount of latex polish was used, it will be absorbed after a while. When the latex is dry, the polish will no longer stick or feel greasy.
If the latex garment is still greasy or not dry, too much polish was used. Wash the latex garment again and repeat the above process, paying special attention to the correct amount.ng out evenly. The latex must be immersed in water.

 

 

Zurück zum Blog